Cooling Tunnel - 10M
Cooling tunnel works as a part of exhaust tunnel. Cooling process is made by open fan pumps feeding with spraying the water to the heated packages from above and sides. System circulates the water received from tanks placed under the tunnel during the operation. At the end of the tunnel package is dried by pressured air. Conveyor belt speed of the cooling tunnel can be adjusted on gradually by electronic speed control system. Cooling tunnel may be manufactured in the desired size and width upon clients' request. The cooling tunnel is made of stainless steel completely.
  • MODEL: CM 025
  • Ip 65 plastic control panel (Hensel)
  • 380 V / 50 HZ
  • Serial phase protection relay
  • Electronic speed control system (Schneider)
  • AISI 304L stainless steel body
  • Bearings with plastic body and stainless steel housing
  • Stainless steel braided band
  • Protection with thermic relay
  • Cooling tank
  • Stainless steel, open fan circulation pump
  • Drying system at the end of cooling system
  • Cooling by side and upper washing
  • Worm gear reducer
  • Length 10643 mm
  • Height 1640 mm
  • Water Consumption Depends on the product
  • Capacity (Min./Max.) Depends on the product
  • Width / Band Width 860 mm / 320 mm
  • Engine Power (Band + Water Pump + Blower) 0,37 kw + 1,1 kw + 7 kw
Share This Page :